Intro and advice request

Hello,

I’ve been interested in knots for nearly as long as I can remember. For some odd reason I never delved much into the topic. However, a few months ago I started dabbling with JD’s “Tying It All Together” paracord projects. Since then the majority of my squadron (I work on helicopters) has started using the stuff I made. Fastrope detachers, snap shackle pulls, rifle slings, etc. It seems logical to continue learning about the topic, especially since I’ve been given an unlimited source of paracord to practice with.

So now my first question; I’m looking for a flat decorative bend that can take a significant load. Every ornate knot I can find is either bulky/rounded (like the Diamond) or collapses into a clump when loaded (like the Carrick). Any suggestions would be appreciated.

And finally, someone might find this handy to know; A section of standard issue rifle cleaning rod can be filed into a superb marlinspike for working with paracord. A picture is attached that also shows my novice handiwork. The standard marlinspike sizes are usually too big for little cord. This makes for a cheap alternative. An additional feature is that the working end can be jammed in the threaded back of the rod.

Hello Cyclotol and welcome.

Glad to have you with us and I like your handiwork.
Some will be very envious of your unlimited supply of chute cord. Don’t go too hard on the stockroom. :wink:

As for the bend suggestions. I need to ask, will this bend be subject to the need to untie it? Most bends are going to morph a bit as they are tightened and especially if the load is great, but then they will compact as well considering the cord you are using.

For a relatively permanent join I would use a double fisherman’s bend and for one that will be more flat and easily untied, I would try the zeppelin bend. Both practical and also nice to look at (I happen to think so at least.).
More to come, I am sure as others weigh in.

SS

I too like the Zeppelin bend though as a decorative bend having the ends at right angles may not be to everyone’s taste. A bend rarely seen is the Tweedledee Bend given the name by Roger Miles in his book “Symmetric Bends”. There is a thread started by Xarax looking at the eye knot version (the Tweedledee Bowline) and there are some excellent photos of how to tie the loop which can easily be used to tie the bend - see http://igkt.net/sm/index.php?topic=3989.msg27204#msg27204.

Another contender is the Sennit Knot - tying instructions can be found at http://www.enm.bris.ac.uk/staff/RRClements/knots/SennitKnot.pdf. This looks a lot more complicated than it is and makes quite a handsome flat bend with the ends lying alongside the standing parts.

Barry

Thank you for the welcome and suggestions. This specific knot will actually be for lacing my wife’s corsets, hence the aesthetic requirement. It does not need to be untied. There’s plenty of excess cord so a jammed knot can just be cut off if more knots are suggested. The results with the Sennit and the Tweedledee bends are attached. The Sennit bend seems to be well suited so far; It’s larger and flatter in appearance than the other suggested knots.

The Zeppelin bend is one of my favourite general purpose knots but aboard the helicopter it often loosens. Too much vibration.


sennit.jpg

tweedle.jpg

One more suggestion - the Ashley Book of Knots (ABOK) no. 1422 (it doesn’t have a name). A bit fiddly to set but it lies flat and looks nice.

Barry

The ABOK 1422 knot suggestion was a goldmine. Thanks Sweeny! It ultimately led to this thread: http://igkt.net/sm/index.php?topic=2694.msg17058#msg17058

The result is attached. Diamond bend with [poorly] tucked ends in flat cord.

A nice looking knot - glad to be of help.

Barry