Knotting for training equipment

I workout several times every week and I often use knots to help me out solving some simple problems. Making handles on rubber bands, hitching them, making a TRX out of lashingstraps and rope etc. I just wanna show one situation where I’m using ropes.

I’m working on an exercise called standing ab wheel rollouts. I’m using an ab wheel and the goal is to rollout on a flat floor from a standing position. I’m using an incline ramp to progress. The ramp is a piece of wood, strengthened by a ladder, resting on wall bars, secured by rope, splicing and knotting.

If you are interested in watching someone perform the excersise with a bit different solution than mine, here is a video:
http://www.youtube.com/watch?v=Bdgi9srx6yY

This is my solution. There are a couple of home made abwheels to the left on the picture, and a commercial one resting on the piece of wood.

http://bildr.no/thumb/868892.jpeg

Close up picture at the side

http://bildr.no/thumb/868894.jpeg

And a close up picture at the front of the knotting

http://bildr.no/thumb/868891.jpeg

When I first tried to design this setup, I was over complicating the knotting. I used a long rope and went first for the trucker hitch, and then the versatackle. Too much rope to pull around, too many and difficult knots, too much work to change the height and angle of the ladder.

What I did was making an eye splice at the end of a short piece of rope. I use the eye to make a girth hitch on the right leg of the ladder. Pull the rope behind the wall bars and make two half hitches on the left leg of the ladder. When adjusting the height, all I have to do is loosen the half hitches and tie the knot over again.

The observant eye might notice whippings :stuck_out_tongue:

I too have used rope to make a few homemade systems for my home gym. :slight_smile:

Feel free to post pictures kno4u :smiley:

This dip station includes tensioned ropes to provide stability in the back and forth direction. My inspiration came from this guy starting at 0:25:
http://www.youtube.com/watch?v=zA9EhzdN1a4

http://i54.tinypic.com/2vbokk1.jpg

http://i56.tinypic.com/2mqrukm.jpg

Looking great, knot4u :slight_smile: Does the setup hold additional weight too?

I can see you had to attach the ropes at two points at two of the corners. It looks like a zeppelin loop and a girth or clove hitch. Are my assumptions correct? :wink:

Hrungnir, that’s a great exercise in your original post. I must make a similar contraption for my home gym…

I had a 300 pound guy use it. It didn’t break. Also, it’s lightweight and can be easily moved and rotated to any side for other exercises.

Here are the knots:
Versatackle A = Girth with Double Bowline, Span Loops, Two Half Hitches on a slip to finish
Versatabkle B = Slipped Buntline with Half Hitch Lock, Span Loops, Two Half Hitches on a slip to finish

The system works just fine, but there is room for improvement. I won’t be making another one in the near future, unless someone wants to buy this one off me.